The RSTMCT123 is a pack of 3 shape of Sorby Turnmaster Tungsten Carbide Cutters: detailed point, round and square. The Detail Point Cutter is used for roughing square wood to round and fine detail work.

For initial external waste removal and straight edge shaping

These tools provide the means of forming perfect beads from 1/8" to 1/2". The nose design permits multiple beads to be cut with precision on spindle for faceplate work.

By Robert Sorby H. S.

1/8" H. S.

High Speed Steel 3 pc Pen Turning Set Set Contains: -5 /16" roughing gouge, (model # 866H) -1/16" parting tool, (model # 865H) -1 /2" spindle master, (model # 879H) (All chisels are 10" long).

An essential tool for between centre (spindle) work. This tool will quickly turn down square timber to round.

By Robert Sorby H. S.

Bowl Gouge by Robert Sorby- 1/2" - 23" Length Deep fluted to allow heavy cuts to be taken. This tool is used over on its side (about 15-20m off the vertical) with the flute pointing in the direction of the cut.

3/8" Bowl Gouge (Long Handle) There is difficulty in achieving this profile. Robert Sorby offers a selection of gouges with a factory ground fingernail profile, which is not only safe in use, but also allows the turner to modify the profile to his specific requirements.

There is difficulty in achieving this profile. Robert Sorby offers a selection of gouges with a factory ground finger-nail profile, which is not only safe in use, but also allows the turner to modify the profile to his specific requirements.

There is difficulty in achieving this profile. Robert Sorby offers a selection of gouges with a factory ground finger-nail profile, which is not only safe in use, but also allows the turner to modify the profile to his specific requirements.

By Robert Sorby H. S.

Hollow Master 3pc Set H. S.

Perfect for scraping / shear scraping inside and outside

For internal shaping and finish. Interchangeable with one tool Indexable, patented cutting head for shear scraping Interchangeable cutter head – no need to buy whole new tool

For undercutting small hollow forms. Interchangeable with one tool. Indexable, patented cutting head for shear scraping Interchangeable cutter head – no need to buy whole new tool. Flat underside for stability. High tensile torx screw/ key for quick cutter release.

For internal waste removal, shaping and finishing