Description
CX101
18" Wood/Metal Band Saw Variable Speeds CX-Series
This Vertical band saw features a variable frequency drive speed control with digital readout, perfect for cutting both wood and various types of metal. Featuring a powerful 1.5HP motor, the inverter motor technology benefits from 3-phase control while using 220V, single phase power.
Changing speeds with the speed control dial means infinite control from 150 to 3000 FPM.
This band saw is heavy, weighing in at 216 kg and features fully balanced cast iron wheels with replaceable rubber tires. The CX101 also features a large precision ground cast iron table (18" x 24") which tilts both left & right, quick release blade tension and upper & lower blade guides.
Like all CX-Series machines, this unit features powder coated paint, sharp looking two tone colours and a full 3 year warranty.
FEATURES
Variable frequency drive with digital readout
Fully balanced cast iron wheels with replaceable rubber tires
Dual tilting table
Quick release blade tension
Upper & Lower blade guides
Powder Coated two tone paint
Made in Taiwan
SPECIFICATIONS
Motor - 1.5HP, 220V, 3PH Inverter Motor
Maximum cutting height: 12"
Throat capacity: 17-1/2"
Variable frequency drive speed control
Blade speed: variable, 150 - 3000 FPM
Precision-ground cast iron table (18" x 24")
Table tilt: 45-degree right, 10-degree left,
Blade length: 133"
Blade width range: 1/8" - 1-1/4"
Left and right table tilting control
Upper and lower blade guides
Rack and pinion adjustment on upper blade guide support
Fully balanced cast iron wheels with replaceable rubber tires
Quick release blade tension
Two 4" dust ports
Wheel brush on bottom wheel
Includes rip fence and miter gauge
Floor to table height: 37-1/4"
Crate Size: 33" x 20" x 79"
Weight: 222 KG
3 Year Warranty
1 Review
-
CX 101 - I like it
I have had my CX 101 for several weeks now and the bottom line is I like it a lot. When first started it up there was some vibration at higher speeds which I believe was caused by belt set. It worked its way out after about ten minutes running. At the lower speeds where I run it for metal cutting it runs very smoothly. I use M42 bi-metal blades and the saw has lots of power for cutting steel. Just be aware that this is a heavy saw and requires two people or one person with shop crane to set it up. The table is very heavy and you should have two people to lift it into place.. One suggesting I have is to adjust the lower blade guides before you put the table onto the machine. The lower inner side guide is hard to get at with the table on and this guide needs adjusting only one when the saw is first set up .
