Description
CT053CH
This canister replacement is designed to fit 1HP dust collectors.
It will fit Craftex model CT053 as well as CT029N and
older Busy Bee models such as B1140.
It can also be retrofitted to most other dust collector brands on the market.
This canister features a V-Weave filter design, similar to the CT029CH.
Filtering area is increased over 6 times when compared to standard cloth bags.
Another plus to the canister filter is the disposal of dust.
Standard bags require you to take off the bag, turn upside down and shake out
the dust sending thousands of fine dust particles airborne.
With the Canister, simply turn the handle located at the top of the canister
to rotate the internal flapper.
The flapper removes dust particles and shakes of caked on dust into the lower
bag of your dust collector.
Dust disposal is now safe, and no longer a chore with this 1 micron canister.
Fits most makes and models of 1 HP dust collectors with a 14.5” diameter
CFM (Cubic feet per minute) is the amount of air the dust collector moves
through itself per minute and depends on factors like the size of the motor
and size of the impeller. Because there is less air resistance with the use
of a canister filter, the CFM increases compared to standard dust collectors.
Improve your health and efficiency.
Daimeter: 14.5”
8 Reviews
-
Canister filter 1micron
Works very well. Perfect addition to my dust collector
-
Canister Filter
Works good. Seems to contain more dust than the cloth bag it replaced. I like the pleat fins for knocking dust down when it comes time to change the bag. Good quality product.
-
Great fit
Tried fitting this on without lubricant and it was just impossible. With silicone lubricant it snaps on perfectly, super tight, and works really well.
-
CT053ch
Unlike some reviewers, mine sealed very tight, not a trace of a leak. But it's a tight fit. So (a) use generous amounts of rubber-friendly lubricant on both the rubber seal and the metal lip, and (b) when it does seat, it does so with a positive "pop" - no gaps from the metal, and sits straight.
-
Works great
I've put it on my CT029N. Put some sliding compound on he last bit of rubber seal to get it over the lip of the "canister". I disconnected the canister from the blower and support bracket so I could see if the lip was seated properly in the groove of the rubber seal. No air leaks at all.
-
Noticeably more suction
Added this to my CT029N and immediately noticed a big increase in air movement. Getting it seated on the dust collector took a little elbow grease, but it was well worth it.
-
More dust in air tan in filter
There is no seal between the bottom of the filter and the rubber. This causes the air to escape between the out side of the filter and rubber blowing dust every where. There is more dust in the air than in the filter. Total waste of money. Stay with the bags.
-
nice addition
added this to my 1HP General dust collector and itd made a big difference. your price was much cheaper than everywhere else i checked as well!