0-6” DigiMag Digital Scale and Magnetic Remote Readout
Vertical & Horizontal Beam 2-in-1 for Router lift, Router table, Planer, & Table Saw
Quick measure speed at 120” per second
Large crystal LCD display
Magnetic & Clamp hardware on remote readout
Inch, inch fractional & metric reading
Mounting hardware included
Accuracy: ±0.002” per 6inch Repeatability: 0.001”
Battery: 3V CR2032 / Environmental Friendly
Reading: 0.001” / 0.01mm / inch fractional
These little DROs are great. So far I've purchased 7 of various lengths. It's an easy upgrade for old machines. The display is not as shown; it's actually much better the the one in the image.
The pre-set button does not work on any of the device’s options
I just finished installing the Z axe after installing the X and Y axes a while back on my mill / drill, I was so satisfied with X and Y that I ordered a 6 in. model for the Z. It repeats to .001 which is as good as the units costing several hundred dollars. I think to attain best accuracy you must set up both ends of the scale equal distance to the connecting point on the data reader.
I purchased the 24", 12" and 6" units and transformed my 25 year old 1 1/2 hp mill/drill into a very accurate machine. I had contemplated doing this 12 months ago at a cost of over $450.00 from an off shore supplier.
0 - 6"