1 MICRON CANISTER FILTER 2HP 3HP DUST CXCANISTER

The filter itself works as prescribed, providing good throughput for airflow and a noticeable improvement in my shop air quality. But... The strap that was included was far lighter gauge than the strap that held the original filter bag. It was also defective because the rivets that hold the locking catch were not properly compressed. The catch flew off the strap when I tried to close it. I ended up gerry-rigging the strap from the filter bag to replace the sub-standard strap that came with the new pleated filter. Very disappointing.

This is an excellent product and it has improved dust collection in my shop, static pressure has improved in the intake duct. The only problem I had was fitting the canister to my Delta Collector. It was a lot of work to the bottom rubber over the Delta rim, but with a lot of lubricant and expletives it finally went on. Tight fit but worth the effort for the results. Good product, price was right and the results - priceless!

My 2hp vacuum system came equipped with a cloth filter. Frankly, it recovered a great deal of dust but dust still spread throughout my shop. The Craftex 1 Micron Filter is amazing. Virtually, 99% of all the dust is trapped creating an almost dust free shop. I would like to mention that the filter took a bit of effort to install as the rubber seal fits very snuggly. With a bit of effort it should be no problem to install if the diameter of your system falls within the published parameters. I highly recommend this product.

This filter makes a significant difference in the power my 2hp system has.

I received the product in damaged condition. Reached out to customer service couple of time and the call gets disconnected when they tried to transfer the call. Product functions as expected but not happy with arrival of damaged product and lack of customer service.

It works. It fits my Penn State Dust collector that is 20 years old.

Sturdily built, and effective. Fitting it to my Trademaster 2 HP system was challenging, (as I knew it would be) I had to add an internal sheet metal sleeve so that the canister would fit, as it was designed for a slightly smaller OD. There is not a lot of give in the bottom rubber. I also needed to seal the joint with good duct tape after fitting. The supplied clamp is very flimsy and broke easily. I used the old bag clamp.

I bought this to upgrade my older Delta 50-850C 1-1/2 hp dust collector. It had the 2 bag system with the upper one acting as the filter, lower as collector. The diameter of each side is approximately 19-5/8", so I was hopeful that I could adapt the canister to fit the top. I had seen a few YouTube videos on the subject. I was pleasantly surprised to find that the canister fit perfectly, snugly, tightly, with relatively little effort fitting in in the upper 'ring' of the collector. No adaptation necessary. The collector works very well with the new canister, but I think I will try to add a baffle to the lower half to act more like a cyclone. This canister is an excellent upgrade for bag-type collectors.

Worth waiting for. Thanks