The Robert Sorby TurnMaster is the first tool in the world to combine three cutting edge technologies in one flexible tool. Cutters are available in tungsten carbide, titanium nitride (TiN) and high speed steel (HSS) providing unsurpassed range to woodturners at every level. The RSTMHCT123 comes with Tungsten Carbide cutters.

By Robert Sorby H. S.

Hollow Master 3pc Set H. S.

Bowl Gouge by Robert Sorby- 1/2" - 23" Length Deep fluted to allow heavy cuts to be taken. This tool is used over on its side (about 15-20m off the vertical) with the flute pointing in the direction of the cut.

Curved Scraper - Robert Sorby The curved end profile makes this excellent for creating, smoothing and blending curved surfaces in bowl and spindle work, eg round bottomed boxes. This new tool is able to take an aggressive cut, whilst retaining the butterfly sensitivity for the refining cuts.

Cutting tools have been produced in 10, 16 and 20 thread per inch, with a unique, enhanced helix angle specially designed for use in wood to compliment these excellent tools. A Relief Cutting Tool Support Rest makes forming internal threads easier and our Thread and Sizing Gauge takes all the guesswork out of dimensioning.

3/8" Bowl Gouge (Long Handle) There is difficulty in achieving this profile. Robert Sorby offers a selection of gouges with a factory ground fingernail profile, which is not only safe in use, but also allows the turner to modify the profile to his specific requirements.

Used with flute downwards. This tool gives an exceptionally good finish even when parting through end grain.

1/8" H. S.

An essential tool for between centre (spindle) work. This tool will quickly turn down square timber to round.

These tools provide the means of forming perfect beads from 1/8" to 1/2". The nose design permits multiple beads to be cut with precision on spindle for faceplate work.

There is difficulty in achieving this profile. Robert Sorby offers a selection of gouges with a factory ground finger-nail profile, which is not only safe in use, but also allows the turner to modify the profile to his specific requirements.

By Robert Sorby H. S.

By Robert Sorby H. S.

There is difficulty in achieving this profile. Robert Sorby offers a selection of gouges with a factory ground finger-nail profile, which is not only safe in use, but also allows the turner to modify the profile to his specific requirements.

The RSTMCT123 is a pack of 3 shape of Sorby Turnmaster Tungsten Carbide Cutters: detailed point, round and square. The Detail Point Cutter is used for roughing square wood to round and fine detail work.

Perfect for scraping / shear scraping inside and outside

For undercutting small hollow forms. Interchangeable with one tool. Indexable, patented cutting head for shear scraping Interchangeable cutter head – no need to buy whole new tool. Flat underside for stability. High tensile torx screw/ key for quick cutter release.

For internal shaping and finish. Interchangeable with one tool Indexable, patented cutting head for shear scraping Interchangeable cutter head – no need to buy whole new tool

For internal waste removal, shaping and finishing